glow plug mod.

[Big Red]

Nissan nz
Introduction : In the event you are presented with a customer
complaining of Engine misfire and blowing smoke after cold start on
UY61/Y61 TD42T models, please follow this procedure outlined below.
Repair Procedure :
1. Test the vehicle at the cold start condition to confirm incidents.
2. If incident is confirmed, install the C/M kit. The C/M kit
consists of the following parts.
Parts name New Parts No Current Parts No
Glow Plugs 11065-VC700 11065 63G00/11065 31 N00
Loop patch harness 11080-VC200AU
3. Replace all glow plugs with C/M ones(described above)
4. Disconnect glow resister on the intake manifold.
5. Disonnect glow resister harness as shown in below photo, resister
is no longer required(cutoff hard aginst the glow resister)
6. Apply sikaflex to the resister to cover the cut wire area as below
photo (cover the exposed wires on the top of the glow resister).
7. Connect loop patch harness in order to by-pass the resister
circuit.
8. Attach the loop Patch connector to the bracket where the resister
connector was installed.
9. Test and confirm operation of Quick Glow system.
(Note the Loop Patch is simple to contact the two terminals. I would
think that you could use the plug from the unused glow resister that
you cut off anyway.)"

[Big Red]

Nissan 11065-63G00 replacement glow plugs
Beru GV921
Bosch GPN-327
Champion CH221
Delphi HDS232
Denso DG-120
Denso DG-198
FAE 74169
Febi Bilstein 19097
Magneti Marelli UC23A
NGK 4937
NGK Y-707RS
NGK Y707RS
Valeo 345157