LED Blinkers

[Big Red]

So the smashed blinkers in Big Reds bullbar probably needed changing rather than fixing so i bought some "L.E.D. autolamps 175AW" lamps to replace them.


also bought a "Tridon HD13" electronic flasher to stop the "flashes too fast" problem.


put it in Big Red [in case you don't know its a 99 GU Patrol Ute] before i fitted the lamps and the fuse blew.
tried another Tridon HD13 in MissRed [in case you don't know its a 00 GU Patrol Ute] and it blew the fuse there also.

The new 3 pin flasher cans plugged straight in to the existing plug but is not compatible with the wiring and no others i could find were compatible either.
will have to rewire it i guess.

original Tridon EP34


electro mechanical type to suit LED's

Tridon HD13 suits 1 to 6 25w globes


Tridon SD13 suits 1 to 10 25w globes

[Big Red]

The offending Bullbar blinkers.


Undo two screws to remove the unit


The mounting holes are about 1/2 a hole out


It is a simple matter to elongate the holes but you could probably just force it in the original holes anyway

[Big Red]

Mount the backing plate


The module clips on securely and is sealed so no need for silicon


I just used standard insulated spade terminals to plug it in
white [earth] goes to the vertical terminal on the right hand side
brown [parker] goes to the top horizontal terminal
yellow [blinker] goes to the bottom horizontal terminal

[Big Red]

The flasher is clipped to a metal rail behind the edge of the centre dash section.
It was a simple matter to make some jumper cables for the wiring of the flasher to flasher plug and swap the green and black wires over.




Job Done !

[Big Red]

Did the same to my other GU but used 176AW instead ... the only difference is they are designed to be viewed at a 24 degree horizontal angle.

also found the narva 3 pin connector fits so used them to connect the wiring.

[Big Red]

this one is supposed to be a direct fit ... no rewiring